Allworx Px 6/2 Guía de instalación Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
Once the command prompt is re-displayed, enter the Px's IP address
(192.168.2.254) into the address field of the PC's web browser and
click Go.
When done, disconnect the PC's Ethernet cable, plug the regular
network cable back in, and power cycle the unit.
-How do I access the Allworx Px 6/2 Expander’s network settings?
In Normal Mode, the settings can be accessed through the Allworx server's
administration web page. Log into the server and go to Network > Port
Expanders. Click on the IP address of the Px unit. This will open a new
browser window or tab containing the Px's web page. From this page, you
will be able to change the settings, view the system event log, access
troubleshooting tools, or change the password. Changing settings and
using the troubleshooting tools requires that a password has previously
been set on the Px. If this has not been done or if you have forgotten the
password, you will need to boot the Px unit into Configuration Mode first
and then set or change the password. See the Configuration Mode FAQ for
instructions on how to enter Configuration Mode.
-How do I access the Px lines directly?
To access lines on the Px unit when testing, you will need to press the
keys 5-7 on a phone to get to the Px unit directly and then type in the port
number you wish to use or test. IE: 57 then Port 00, 01, 02… Follow with
the digits 0-0. To dial the CO line configured on Px port 2, dial 570100.
-Can I remotely troubleshoot an Allworx Px 6/2 Expander that is
behind a firewall?
Yes. In order to access the Px unit remotely, you will need to have access
to the LAN of the remote site. If you do not have a VPN tunnel available,
you may use a remote connection to a PC on the LAN. Then navigate via
web browser to the LAN IP of the Px.
-Can I remotely troubleshoot an Allworx Px 6/2 Expander?
In order to access the Px unit remotely, you will need to have access to
the LAN of the remote site. If you do not have a VPN tunnel available, you
may use a remote connection to a PC on the LAN. Then navigate via the
web browser to the LAN IP of the Px.
Vista de pagina 10
1 2 ... 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios